CLR-C-HT
Description
The ClareOne Rate-Of-Rise heat detector uses a built-in thermistor to sample and report on a specific set temperature or a sudden rise in temperature.
Heat – selectable 135F or 200F
Rate of Rise – rapid temp rise 12F per minute
Note: The device is powered by a 3V lithium battery providing up to 10 years of battery life.
Installation
Heat detectors are normally installed in areas that are prone to smoke such as kitchens and garages.
Installation notes:
- Avoid areas that may have rapidly increasing temperatures such as fireplaces, stoves, heaters, etc.
- When mounting the detector should be placed on a ceiling at least 4 inches away from any wall. If placed on a wall the detector must be within 6 inches of the ceiling.
- If using the sensor with the heat setting at 135°F make sure the ceiling location does not exceed this temperature.
Setup:
The detector can be setup to detect a fixed temperature of either 135F or 200F.
Low – 135F
High – 200F
Note: if no jumper is installed the detector is set to 200F
To set detection temperature: Use the jumper to select Low or Hi.
Programming
To add the sensor to your panel and for detailed programming instructions, refer to the ClareOne Wireless Security and Smart Home Panel User Manual (DOC ID 1871).
To add the detector:
- Put the ClareOne panel in “add mode” and follow the displayed instructions for adding the sensor.
- Open the sensor body case and depress the tamper switch.
- Exit “add mode.”
Mounting the detector
- Locate the base mounting holes and mount the base to the wall or ceiling with the appropriate hardware.
- Attach the detector to the mounting base.
Replacing the batteries
Battery life depends on the temperature of the installation environment. When the battery voltage gets low, the detector transmits a low battery signal to the panel. The panel then activates trouble beeps to notify the customer that the detector battery must be replaced.
Replace the battery immediately when this condition occurs, using the following battery: Panasonic CR123A 3V
Battery disposal
The batteries used in this sensor are lithium batteries and are not reusable. Be sure to properly dispose of used lithium batteries according to your local hazardous waste disposal laws.
Specifications
Compatible panel |
ClareOne (CLR-C1-PNL1) |
Transmitter frequency |
433MHz |
Encrypted |
Yes |
Transmitted indications |
Tamper and low batter |
Supervisory keep-alive |
60 to 70 minutes |
Maximum UL spacing |
50 x 50 ft (15.2 x 15.2 m) |
Rate of rise rating |
12 to 15°F (6.7 to 8.3°C) |
UL max ambient ceiling |
100 to 150°F (37.8 to 65.6°C) |
Battery type |
CR123A |
Battery life |
8 to 10 years |
Temperature detection |
135º F rate of rise |
Heat rate of rise detection |
15º F per minute |
Operating environment Temperature |
|
Dimensions |
2.29 × 1.28 in. |
Certifications |
FCC: 15.109 Class B 15.231, Industry Canada: ICES-003, RSS-210 |
Full PDF - ClareOne Rate-of-Rise Heat Detector Installation Sheet (DOC ID 1945)