CH-RTS3 Installation Guide

Introduction

The CH-RTS3 is a two wire remote flush mount temperature sensor. It is designed for use with the CH-THSTAT-W and the CH-THSTAT-Z.

Features

• Type 2 Curve
• Flush Mount
• ¾” disk
• Self-threading wall insert
• ½” pilot hole
• 2 wire
• 10K Thermistor Style

Technical Specifications

The CH-RTS3 technical specifications, including the dimensions, wiring requirements, and installation instructions are found below.

Wiring Requirements

The CH-RTS3 sensor wires must be extended. Select one of the following methods.

• Thermostat wire, maximum length of 250ft
• Twisted pair (22GA), with a max length of 250ft.
• Cat 3/5/6 cable (24GA) with a max length of 100ft for a single pair, or 200ft for a double pair.

When connecting the sensor wires to the thermostat base select the RS1 or RS2 sensor contacts.

Installation

The CH-RTS3 is designed for a flush mount in the wall or ceiling. Follow the instructions below for proper installation.

To install the CH-RTS3:

1. Drill a 1/2” pilot hole in the desired location.

2. Screw the self-threading remote sensor into the wall.

3. Press the temperature sensor into the wall mount.

Full PDF - CH-RTS3 Installation Guide (DOC ID 1169)